User manual

27
PTZ CAMERA SETTING AND CONTROL
1. Introduction:
Connect the Signal I/O box to the DVR. The signal I/O box has RS485 ports for PTZ
camera control.
2. Installation:
2.1 Setting PTZ camera control protocol:
Follow PTZ camera user manual to choose and setting control protocol, all the
camera need to choose same protocol type.
2.2 Setting PTZ camera ID:
Follow PTZ camera user manual to set PTZ ID, each camera has a unique ID
it’s own. We suggest stronger CH1 camera use the ID no: 1, CH2 camera use
the ID no: 2 …, that you will have more convenience to control your PTZ
cameras.
Follow the figure to connect all of cameras RS485 TX together and RX together, then
insert RS485 TX into the RS485 TX terminal and RX insert into the RS485 RX
terminal and tight it.
3. PTZ control setting:
3.1 Go to DVR menu and select system, into system list and select subject of
PTZ/Keyboard, then use left and right keys to select protocol to match your PTZ
camera setting.
3.2 Use up and down keys to select subject of baud-rate, then use left and down
keys to select baud-rate to match your PTZ camera setting.
3.3 Use up and down keys to select subject of ID, then use left and down keys to
select ID to match witch PTZ camera you want control now.
3.4 If you want to set auto pan, you can select auto pan=on. Go to auto-pan setup
and use up/down/right/left keys to set the start point and end point. Press cam1
save right position, cam2 save left position and press cam3 demo auto pan, and
then use Menu key to quit PTZ setting.
3.5 Example:
PTZ Protocol: Pelco P
Baud rate: 9600 bps
ID: 1
Auto pan: on