User manual

21
* Set “ALARM/MOTION RECORD” mode and then select “PRE-RECORD: ON”.
The system will record 100 images in the hard disk before event detected
motion.
F Press key to exit for other setting or press key and keep more than 2
seconds to exit OSD setting operation.
8. System Setup Operation
A. Press key to enter menu selection mode.
B. Use / key to select [SYSTEM SETUP] setting section.
C. Press key to enter [SYSTEM SETUP] select mode.
a. Alarm In: for select alarm in channel to set Alarm In, Re-Action and Alarm Out
on/off.
* Normal Close: The signal loop is closed under normal conditions. When the loop
becomes open, alarm will be triggered until the loop becomes closed again. In
other words, if the loop keeps on open for a period of time, alarm will keep on
triggering in that time interval.
* Normal Open: The signal loop is open under normal conditions. When the loop
becomes closed, alarm will be triggered until the loop becomes open again. In
other words, if the loop keeps on closed for a period of time, alarm will keep on
triggering in that time interval.
SYSTEM SETUP：
ALARM IN
PASSWORD
PTZ
AUDIO
DISPLAY
DIALER/GPS
DVR ID
FACTORY DEFAULT
UPDATE CODE FROM HDD
ALARM IN
ALARM IN1
ALARM IN2
ALARM IN3
ALARM IN4
ALARM IN1
ALARM IN ：
：：
：NORMAL CLOSE
RE-ACTION ：CH01 (CH01~04)
ALARM OUT
：
OFF
(or ON)