User manual

User Manual for Mobile DVR

6.2. （Application program）upgrade

Upgrade same as 6.1

6.3. MCU upgrade

1. Make the upgraded file to be copied to SD card or at hard disk, then change the file name as Boot_flash.bin.

please be sure that make the file copied completely

2. Insert SD card or Hard disk when device in disconnect electricity statues

3. It will upgrade automatically after device power on.

4. Check out the updated version through press “INFO” key on remote control, or via “System Info” in device

menu to check it.

Remark:

① Please make sure never do any operation during upgrading

② Make sure all the all the upgraded files are in SD card or hard disk. Power must be off before upgrade

③ If user have to upgrade device again, please be noted that the same version cannot be upgraded to it

④ The correct upgrade sequence is file system upgrade, application program upgrade and the last one is MCU

upgrade

⑤ When device re-start during upgrading, it means upgrade has finished automatically.

6.4. Edition number

Press key 【INFO】 on the remote control, enter in the menu ‘System info’ to check the edition.

6.5. Restore to factory default

Enter in management menu, restore to factory default, the device will restart to the monitor state.

Attention:：

①While the device upgrade, please make sure not to have any other operation；

②Make sure the upgrade file is saved in SD card or HDD, also the device should be power off before upgrade；

③The upgrade sequence is: File system, Application system, SCM；

④The device will restart against upgrade finished.

⑤Device had restored to factory default.

HTTV5.0X-APP-*******.crc