MSDS

BRIGHT WHITE BASE RECLAIM
Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Regulation (EU) No. 453/2010 -
United Kingdom (UK)
SECTION 7: Handling and storage
:
Industrial sector specific
solutions
Not available.
Product/ingredient name
Exposure limit values
Recommended monitoring
procedures
Occupational exposure limits
If this product contains ingredients with exposure limits, personal, workplace
atmosphere or biological monitoring may be required to determine the effectiveness
of the ventilation or other control measures and/or the necessity to use respiratory
protective equipment. Reference should be made to monitoring standards, such as
the following: European Standard EN 689 (Workplace atmospheres - Guidance for
the assessment of exposure by inhalation to chemical agents for comparison with
limit values and measurement strategy) European Standard EN 14042 (Workplace
atmospheres - Guide for the application and use of procedures for the assessment of
exposure to chemical and biological agents) European Standard EN 482
(Workplace atmospheres - General requirements for the performance of procedures
for the measurement of chemical agents) Reference to national guidance
documents for methods for the determination of hazardous substances will also be
required.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts. If contact is possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: safety glasses with side-shields.
Eye/face protection
:
:
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and
safety showers are close to the workstation location.
8.2 Exposure controls
Hygiene measures
:
No DNELs/DMELs available.
PNECs
No PNECs available
SECTION 8: Exposure controls/personal protection
The information in this section contains generic advice and guidance. The list of Identified Uses in Section 1 should be
consulted for any available use-specific information provided in the Exposure Scenario(s).
8.1 Control parameters
DNELs/DMELs
Individual protection measures
Titanium dioxide
EH40/2005 WELs (United Kingdom (UK), 12/2011).
TWA: 10 mg/m³ 8 hours. Form: inhalable dust
TWA: 4 mg/m³ 8 hours. Form: respirable dust
Silica gel, pptd., cryst.-free
EH40/2005 WELs (United Kingdom (UK), 12/2011).
TWA: 6 mg/m³ 8 hours. Form: inhalable dust
TWA: 2.4 mg/m³ 8 hours. Form: respirable dust
Aluminium hydroxide
EH40/2005 WELs (United Kingdom (UK), 12/2011).
TWA: 2 mg/m³ 8 hours.
Diiron trioxide
EH40/2005 WELs (United Kingdom (UK), 12/2011).
TWA: 10 mg/m³ 8 hours. Form: inhalable dust
TWA: 4 mg/m³ 8 hours. Form: respirable dust
6/12