FallDetect_UserGuide_ _05mech.
FallDetect_UserGuide_ _05mech.
Fall Detect System Features Power Cord Multi-color indicator Emergency Help Button Technical Support use only Rechargeable Fall Button Charging Cradle 3 FallDetect_UserGuide_MHP8002-009H_05mech.
If you have any questions, please call 4 FallDetect_UserGuide_ _05mech.
Charging Instructions recommend you charge the Fall Button every night. Plug the power cord into an electrical outlet that is not controlled by a light switch. 5 FallDetect_UserGuide_ _05mech.
Testing The Fall Detect Button Please have the complete system near you at the time of testing. Press the Fall Detect 6 FallDetect_UserGuide_ _05mech.
Testing Fall Detection Fall detection can be tested by dropping the Fall Button from a height of 4 feet. The Fall Detect Button can take up to 20 seconds to interpret the movement and determine if an actual fall Please do not pick up the pendant before the test is completed, as it may interpret this as normal movement and cancel the test. of beeps.
Important Safety Information The Fall Detect Button does not detect 100% of falls. If you are able, please press the Help Button when you need assistance. The Fall Detect Button will work approximately 300 feet from the Mobile Device or 600 feet from the Base - To prevent the Fall Detect Button from accidentally activating while you sleep, please shorten the length of your lanyard so that the pendant rests at chest level.
Fall Detect Button Light Indicator Off Red Off Flashes and beeps No alarm detected Button has been pressed or fall is detected Red Flashes every minute, beeps every hour Red Long beep and flash Battery is critically low, pendant is shutting down Yellow Flashes and beeps Early warning of fall detected, about to alarm Green Flashes and beeps Alarm has been cancelled All Red, yellow, green, beeps Battery is low and pendant must be charged Pendant power is turned on or restarting 9 FallDetect_
Fall Detect Button Frequently Asked Questions What happens if I fall? If you fall, a signal will automatically be sent for help, unless the button detects normal movement. : Within a few seconds after a fall, the Fall Detect Button will enter the CAUTION phase. The pendant will start beeping and flashing yellow for 10 seconds. The CAUTION phase is a time period of screening for additional normal movement to potentially self-cancel the alarm.
How can I cancel a Fall Detect alarm? Alarms can be manually cancelled by pressing and holding the pendant’s Emergency Button for If the alarm is not cancelled, an Emergency Operator will communicate with you through the Base Will my Fall Detect Button work outside my home? Yes, the Fall Button Automatic Fall Detect Button works outside of the home, as long as it is within range of the Mobile Device. How do I call for help? are able to speak, please provide your status.
Is the lanyard adjustable? There are two connectors on the lanyard. One that is cone shaped and one Do the reverse to tighten the lanyard. Can a magnetic lanyard cause interference with a pacemaker or other medical device? If you have a pacemaker or any medical device, consult your manufacturer for information on any possible risk of magnetic interference with the device. How long will the battery last? The battery on a single charge can last up to 45 days.
Is the lanyard breakaway? Yes, with a tug the lanyard will break away. If I accidentally set off the Fall Detect alarm, what do I do? no further action will be taken. Can I replace the Neck Pendant cord? chains or necklaces. However, the risk of choking may increase if you do not use the lanyard provided Can I speak into my Fall Detect Button? Is the Fall Detect Button waterproof? The pendant is water resistant and can be worn in the shower. 13 FallDetect_UserGuide_MHP8002-009H_05mech.
FCC Statement against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Technical Information 1.5 A Battery Backup 1.5 A Internal 930 mAh Internal 1200 mAh Internal 230 mAh Internal 230 mAh Internal 230 mAh 1000 mA 1A 1A 3000 mA Battery Backup 3000 mAh Battery Backup 3000 mAh 3000 mA Internal 930 mAh Internal 1000 mAh Battery Backup 3000 mAh Battery Backup 3000 mAh 3000 mA 2000 mA 2000 mA TBS Battery Backup 3000 mAh Battery Backup 3000 mAh 15 FallDetect_UserGuide_ _05mech.
FallDetect_UserGuide_ _05mech.
