RS-36M VHF Marine Handheld Radio FCC ID:2AGRS-RS36M
This device complies with FCC ules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and ( ) this device must accept any interference received, including interference that may cause undesired operation. Changes or modi cations not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment.
The radio floats in fresh or salt water when the supplied accessories are attached.
Connect the supplied flexible antenna to the antenna connector, rotate it clockwise until it is tight. o listed is has Power Button If battery charging is full, LCD appears “FL”, you should remove the adaptor. NOTE: If you have not inserted the battery pack, the LCD will show "Er".
Hold and turn radio ON to selected ANTENNA NOTE: Ensure the cap for the DC charging connector is affixed correctly to avoid water ingress.
The selectable channel groups are different, depending on the version. Each regular channel group has separate leisure-use call channels. The call channel is monitored during tri-watch. The call channels can be programmed and are used to store your most frequently used channel in each channel group for quick recall. seconds S S ing Appears “WX ALT” when the weather alert function is ON. function, the squelch must be adjusted to the proper level. Channel 16 is the distress and safety channel.
s activate flash Scanning channel readout When a signal is received, the scan pauses until the signal disappears or resumes after pausing 5 seconds, depending on the set mode setting. will flashing.
The set mode is used to channel the settings of the transceiver’s functions: beep tone function, priority scan function, scan resume timer, auto scan function, dual/tri-watch function, monitor key action, automatic backlighting, LCD contrast setting and power save function. transceiver.
remains open remains open inactivity. The power save function reduces current drain by turning OFF the receiver circuit for preset intervals.
programming . TX: 156.025 – 157.425MHz RX: 156.000 – 163.
