Operating Instructions and Installation Instructions

7835-6-00
FR NL
GB
GB
DE
SL
PL
DK
FI
NO
SE
SRRO
HU SK
LT
LV
ES PT
HRIT
TR
GR
CZ
RU
KO JP CN
ETUA
THMY
ARHE
TW
A
A
To install the child car seat in the car extend the Seatx connectors
(A). Press the locking levers at the sides of the seat and pull back
the Seatx connectors until the limit stop is reached.
2.2 Installing in the vehicle with the Seatx
Attention!
Always use the vehicle's 3-point seat belt with the impact shield
when securing your child! The Seatx system improves the level
of protection in the event of a side impact, and secures the seat
when it is not in use.
Insert the insertion aids through the upholstery slit in the back rest
and seat and attach to the Isox attachment brackets. This is not
necessary where insertion aids are already permanently installed.
Ensure that the open side is facing upwards.
Lock the Seatx connectors (A) onto the Isox attachment bracket,
making sure the green mark on both connectors is visible. Check
that they are rmly locked by pulling both sides of the seat.
Then push the child car seat, with the locking levers pressed
down, towards the vehicle seat until the back rest is positioned up
against the back rest of the vehicle seat.
Zum Einbau in Ihr Fahrzeug müssen die Seatx- Konnektoren
(A) ausgefahren werden. Dazu drücken Sie die Rasthebel an den
Seiten des Sitzteils und ziehen die Seatx-Konnektoren nach
hinten bis zum Anschlag heraus.
2.2 Einbau ins Fahrzeug mit Seatx
Achtung!
Zur Sicherung Ihres Kindes immer den fahrzeugeigenen Drei-
punktgurt zusammen mit dem Fangkörper verwenden! Das Seatx
System verbessert den Schutz beim Seitenaufprall und sichert den
Sitz bei Nichtgebrauch.
Stecken Sie die Einführhilfen durch den Polsterschlitz von Rücken-
lehne und Sitzäche auf die Isoxbügel. Dies ist nicht erforderlich
bei bereits fest installierten Einführhilfen. Achten Sie darauf, dass
die offene Seitenäche nach oben zeigt.
Rasten Sie die Seatx-Konnektoren (A) in die Isox- Bügel ein,
dabei muss die grüne Markierung an beiden Konnektoren sichtbar
werden. Prüfen Sie das sichere Einrasten durch beidseitiges
Ziehen an der Sitzäche.
Schieben Sie den Kindersitz nun mit gedrückten Rasthebeln in
Richtung Fahrzeugsitz, bis er mit der Rückenlehne an der Rücken-
lehne des Fahrzeugsitzes ächig anliegt.