Operating Instructions and Installation Instructions

7839-6-00
FR NL
GB
GB
DE
SL
PL
DK
FI
NO
SE
SRRO
HU SK
LT
LV
ES PT
HRIT
TR
GR
CZ
RU
KO JP CN
ETUA
THMY
ARHE
TW
A
A
13
14
15
3.2 Installing with the Seatx
Attention!
Always use the vehicle's 3-point seat belt to secure your child! The
Seatx system improves the level of protection in the event of a
side impact, and secures the seat when it is not in use. Insert the
insertion aids through the upholstery slit in the back rest and seat
and attach to the Isox attachment brackets. This is not necessary
where insertion aids are already permanently installed. Ensure that
the open side is facing upwards.
To install the child car seat in the car extend the Seatx connectors
(A). Press the locking levers at the sides of the seat and pull back
the Seatx connectors until the limit stop is reached.
Lock the Seatx connectors (A) onto the Isox attachment bracket,
making sure the green mark on both connectors is visible. Check
that they are rmly locked by pulling both sides of the seat. Then
push the child car seat, with the locking levers pressed down,
towards the vehicle seat until the back rest is positioned up against
the back rest of the vehicle seat.
3.2 Einbau mit Seatx
Achtung!
Zur Sicherung Ihres Kindes immer den fahrzeugeigenen
Dreipunktgurt verwenden! Das Seatx System verbessert den
Schutz beim Seitenaufprall und sichert den Sitz bei Nichtgebrauch.
Stecken Sie die Einführhilfen durch den Polsterschlitz von Rücken-
lehne und Sitzäche auf die Isoxbügel. Dies ist nicht erforderlich
bei bereits fest installierten Einführhilfen. Achten Sie darauf, dass
die offene Seitenäche nach oben zeigt.
Zum Einbau in Ihr Fahrzeug müssen die Seatx- Konnektoren
(A) ausgefahren werden. Dazu drücken Sie die Rasthebel an den
Seiten des Sitzteils und ziehen die Seatx-Konnektoren nach
hinten bis zum Anschlag heraus.
Rasten Sie die Seatx-Konnektoren (A) in die Isox- Bügel ein,
dabei muss die grüne Markierung an beiden Konnektoren sichtbar
werden. Prüfen Sie das sichere Einrasten durch beidseitiges
Ziehen an der Sitzäche. Schieben Sie den Kindersitz nun mit
gedrückten Rasthebeln in Richtung Fahrzeugsitz, bis er mit der
Rückenlehne an der Rückenlehne des Fahrzeugsitzes ächig
anliegt.