Installation Guide
REC TwinPeak Installation Manual - IEC /
Rev E . Ref: NE
MECHANICAL INSTALLATION
FIRE GUIDELINES
REC TwinPeak panels have a Class C fire classification. Utilize the following fire safety guidelines when installing REC TwinPeak panels:
• Check with local authorities for fire safety guidelines and requirements for any building or structure on to which the panels will be
installed.
• The system design must ensure that it can be easily accessed in the event of a building fire.
• Check with local authorities for applicable regulations concerning setbacks or other placement restrictions that may apply for roof-
mounted arrays.
• The use of DC ground fault interrupters is recommended. This may also be required by local and national codes.
• All electrical appliances are a fire risk. The panel must therefore be mounted over a fire retardant roof covering rated for the application
and a distance of mm between the panel and the mounting surface, allowing free circulation of air beneath the panels must be
respected at all times.
ORIENTATION
To maximize system output, panels should be installed at the optimum orientation and tilt angle. The specifics of this depend on location and
can be calculated by a qualified system designer.
Dependent on local conditions, a lower angle of installation will potentially increase the requirement for regular cleaning.
The optimal mounting position of panels results in the sun’s rays falling perpendicular (i.e., at °) to the surface. All panels in a string should,
wherever possible, have the same orientation and tilt to ensure the system does not underperform due to mismatched outputs.
The panels should not be exposed to artificially concentrated light.
ENVIRONMENTAL FACTORS
REC TwinPeak panels are designed to provide decades of durable and stable output. Ambient operating temperatures must be between
and +°C.
The panels are not suitable for installation in potentially hazardous locations nor should they be installed in the following locations:
• Near sources of flammable gases or vapors e.g., gas stations, gas containers or spray paint facilities.
• Near open flames.
• Under water or in water features.
• Where exposed to sulfur e.g., near sulfur springs or volcanoes.
• Where the panels may be exposed to harmful chemicals.
Ensure panels are not exposed to direct contact with salt water/spray and avoid installation in areas subject to high salt mist
content.
For installations on water e.g., floating pontoons, see Annex 1 at the rear of this manual.
PANEL HANDLING
To avoid damage to the solar cells and other components, all solar panels should be handled with care and protected from damage at all times.
All warnings and instructions on the packaging should be observed. Follow these guidelines when unpacking, transporting or storing panels:
• Record the serial numbers prior to installation and note the information in the system documentation.
• Carry the panels using both hands and do not use the junction box as a grip.
• Do not allow the panels to sag or bow under their own weight when being carried.
• Do not subject the panels to loads or stresses, e.g., leaning on them or through the placing of weight on them.
• Do not stand on the panels.
• Avoid dropping the panels as any damage caused may be unseen.
• Keep all electrical contacts clean and dry.
• Store panels in a dry and properly ventilated room.
• Do not apply force to the backsheet.
• Avoid using sharp or pointed objects if panels require marking.
• Never apply paints, adhesives or detergents to the back of the laminate.
• Do not use any solar panel that is damaged or been tampered with.
• Never aempt to disassemble, modify or adapt the panels or labels in any way as this will void the warranty.
Do not use a panel which is broken or damaged. If the panel front glass is broken or laminate back sheet is damaged, it can expose
personnel to hazardous voltages.