Specifications

Left & Right Hand ADA Compliant
Folding Transfer Bench with Legs
Installation & Load Bearing:
Under no circumstances should any shower seat be mounted to drywall, sheetrock, plas-
ter, fiberglass, acrylic or other similar "hollow" wall surfaces without appropriate wood or
steel backing material.
To Be Specified When Ordering:
Wood Species
Orientation ❏ Left ❏ Right
Finish ❏ Natural ❏ Oiled Finish*
Due to limitations in the printing process, actual colors may vary.
*Oiled Finish only applies to Burmese Teak & Plantation Teak
■
Heavy Duty Type 304 18 gauge Stainless Steel
W
all Brackets, Supports and Frame
■ Seat remains in raised position until you
pull it down
■ Low pressure spring action makes it easy to raise
and lower the seat
■ Each leg is capped with a soft rubber Grip-Rite
foot.
■ Rounded edges on seat battens for comfort and
safety
■ Seat battens are spaced to allow water to drain
through
Dimensions:
■ 32"L x 22
1
⁄2"D (812.8 x 571.5mm)
Height Range: 17" to 19" (431.8 to 482.6mm)
Options:
■ Left or Right Orientation
■ Natural or Oiled Finish
■ Burmese Teak, Garapa, Plantation Teak, Cypress
or White Cedar
Burmese Teak Plantation Teak Garapa Cypress
21"
1
1/2
"
17" to 19"
A.D.A. Min/Max
Stainless
Crossmember
22
1/2
"
13
1/2
"
Flange
4
1/4
"
32"
13
1
/2
"
13
1
/2
"
21"
20"
All shower seats must only be installed using suitable fasteners and sufficient in-wall backing
materials. ADA mounting height for lowered seat is 17" (432mm) to 19" (482mm). When
properly installed, all shower seats have been designed and manufactured to support
loads exceeding the downward pull requirements for Federal specifications FHA, VA,
HUD, hospital codes, and private construction. The actual "in use" load bearing
capacity of any shower seat, however, will be limited by the strength of its mounting sur-
face and installation hardware. The manufacturer recommends that shower seats be
installed using 2" minimum thickness "in wall" solid wood blocking material with #10 x 2"
stainless steel, phillips-head, sheet metal screws, or using a wall embedded,
minimum 12 ga. (2.8mm) steel anchor plate with #10 x 24 stainless steel machine
screws.