Specifications

ADA Compliant Folding Transfer Bench
■ Heavy Duty Type 304 Stainless Steel Wall
Brackets, Supports and Frame
■ Seat remains in raised position until you
pull it down
■ Low pressure spring action makes it easy to raise
and lower the seat
■ Rounded edges on seat battens for comfort and
safety
■ Seat battens are spaced to allow water to drain
through
Dimensions:
■ 32"L x 16"D (457.2 x 406.4mm)
Height Range: 17" to 19" (431.8 to 482.6mm)
Options:
■ Natural or oiled finish
■ Burmese Teak, Garapa, Plantation Teak, Cypress
or White Cedar seat
Installation & Load Bearing:
Under no circumstances should any shower seat be mounted to drywall,
sheetrock, plaster, fiberglass, acrylic or other similar "hollow" wall surfaces
without appropriate wood or steel backing material.
To Be Specified When Ordering:
Wood Species
Orientation ❏ Left ❏ Right
Finish ❏ Natural ❏ Oiled Finish*
Due to limitations in the printing process, actual colors may vary.
*Oiled Finish only applies to Burmese Teak & Plantation Teak
14½"
Flange
Slide Box
17" to 19"
A.D.A. Min/Max
14"
4¼"
6¾"
1½"
16"
2½"
11½"
32"
3" Flanges
14½"
3"
Burmese Teak Plantation Teak Garapa Cypress
All shower seats must only be installed using suitable fasteners and sufficient
in-wall backing materials. ADA mounting height for lowered seat is 17"
(432mm) to 19" (482mm). When properly installed, all shower seats have
been designed and manufactured to support loads exceedingthe
downward pull requirements for Federal specifications FHA, VA, HUD,
hospital codes, and private construction. The actual "in use" load bearing
capacity of any shower seat, however, will be limited by the strength of its
mounting surface and installation hardware. The manufacturer
recommends that shower seats be installed using 2" minimum thickness
"in wall" solid wood blocking material with #10 x 2" stainless steel,
phillips-head, sheet metal screws, or using a wall embedded, minimum
12 ga. (2.8mm) steel anchor plate with #10 x 24 stainless steel machine
screws.