User Manual

Version Number: Mig210-20201221A1
2
wire feeding speed are automatically matched. Only when the deviation is too large, it can be adjusted appropriately. Inductance
adjustment: If the splash is too large or the welding pool is not deep enough, it can be adjusted to a larger value, otherwise it can
be smaller.
7. Positive Terminal
Positive Terminal. Welding current flows from the power source via heavy duty bayonet type terminals. It is essential, however,
that the male plug is inserted and turned securely to achieve a sound electrical connection.
8. Negative Terminal
Negative Terminal. Welding current flows from the power source via heavy duty bayonet type terminals. It is essential, however,
that the male plug is inserted and turned securely to achieve a sound electrical connection.
9. Mig Welding torch connector
10.Polarity selection plug
Part 2: Introduction to the product and configuration list
No.
Picture
Name
Qty
Remark
1
RBM2100
1
Please check outside of the whole machine
no scratch and break , it can power on
normally
2
MB15
welding
torch
1
3M, MB 15 MIG welding torch, European
central plug
3
Welding
holder
1
2m 16MM2 cable, 300A copper American
welding holder +10-25mm2 European quick
plug
4
Ground
clamp
1
2m 16MM2 cable, 300A Ground clamp
+10-25mm2 European quick plug
5
Conversion
line
1
Conversion line only suit for 220V to 110V
dual-voltage input machines, if not dual-
voltage machines no this line included.
6
Transparent
hose
1
3m 8*12 transparent network hose
7
Hose clamp
2
Used to fix the trachea to prevent air leakage