User Manual

Version Number: Mig210-20201221A1
14
5
、
Set drive roll
Face the side marked 0.030” away from the machine
Remarks: 1. There are two grooves on one wire feed wheel, one side is 0.030” (0.8mm) and the other side is
0.040” (1.0mm) to match the corresponding wire diameter.
2. Gear wire feed wheel, gear wire feed wheel is suitable for flux-cored welding wire, our standard
configuration has 1 piece of 1kg flux-cored welding wire, which can be directly installed and used。
6、Feed wire and set pressure
7、Connect to Input Power
Please refer to the digital sign on the rear panel of the machine for input voltage. Connecting the wrong voltage
will damage the machine.