User Manual

Version Number: Mig210-20201221A1
11
4. “V”，If you are not satisfied with the automatic adjustment of the machine, you can fine-tune the voltage
(when the current and wire feeding speed are unchanged), "inductance", during the welding process, it
feels that the welding pool is not deep enough and the splash is too large, so you can adjust
it appropriately .
13、With contact tip 1/4” from metal, depress trigger completely to initiate arc
14、To replace the welding wire.
Use the cutting pliers to cut off the front section of the contact tip that is more than the welding wire, loosen
the wire feed mechanism pinch wheel, rotate the welding wire reel clockwise, turn the welding wire back to the wire
feed reel, pay attention to pinch the welding wire with your right hand to avoid the wire bounce。
15、Structure of welding gun