User Manual

32
English
1 Product brief introduction
1.1 Technical parameters
Machine type RBM 2100 No load voltage (V) 50±5
Supply voltage (V) 1 phase AC 230V±15% Duty cycle (%) 60
Frequency (Hz) 50/60 Power factor 0.7
Rated Max.Input current (A) 30(MIG)/27.4(MMA)/16.7(TIG) Efficiency (%) 85
Output current adjustment (A) 40-200(MIG)/30-150 (MMA)/30-150 (TIG) Wire feeder type All-in-one
Output voltage (V) 16.0-24.0(MIG)/21.2-26(MMA)/11.2-16 (TIG) Wire diameter (mm) 0.8/1.0
Wire feed speed (m / min) 2-15 Insulation grade F
Enclosure protection class IP21 Net Weight (kg) 14
Suitable plate thickness (mm) 0.5-5 Overall dimension(mm) 470
×
320
×
376
1.2 Accessories list
2 Installation instruction
2.1 Welding wire Installation steps:
The wire holder filled with wire installed on the wire feeder. The hole position of the wire plate should be aligned with the fixed plug on the shaft.
The wire coil should be rotated and loosen the wire, to prevent the wire from loosening, the new wire disk head is usually inserted into the fixed hole at the
edge of the wire. In normal use, to prevent the bending of the wire to be stuck, please cut this part of wire.
0.030
”
(0.8mm)/0.040
”
(1.0mm)diameter 0.030
”
(0.8mm)/0.040
”
(1.0mm)diameter
4
”（
100mm 1kg
）
wire spool 8
”
(200mm 5kg)wire spool
According to the diameter of the wire, choose different wire feed roller.V roller for stainless steel and carbon steel. Knurled roller for flux cored wire. Please
match diameter notes on the roller with the welding wire diameter. Loosen the pressure wheel nut, to pass through the guide wire tube into the wire feed
wheel groove, adjust the pressure wheel pressure welding wire, guarantee the welding wire is not sliding, and not blocking while feeding the wire.
Roller size: external diameter
∮
30mm/ internal diameter
∮
10mm/ height 10mm
RBM2100*1
MIG Welding Gun
Torch*1
Welding Electrode
Holder Set*1
Gas hose*1 Flux Cored
Welding Wire*1
Earth Electrode Holder
Set*1