Use and Care Manual

-4-
GENERAL SAFETY RULES
WARNING!
SAVE THESE INSTRUCTIONS!
Refer to them often and use them to instruct others.
READ AND FULLY UNDERSTAND ALL INSTRUCTIONS
AND WARNINGS PRIOR TO USING THIS UNIT. YOUR
SAFETY IS MOST IMPORTANT! FAILURE TO COMPLY
WITH PROCEDURES AND SAFE GUARDS MAY
RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE.
REMEMBER: YOUR PERSONAL SAFETY IS YOUR
RESPONSIBILITY!
6. Be sure the Stuffer is stable during
use. All four feet should be secure on a level
surface. The Stuffer should not move during
operation.
7. NEVER operate the Stuffer with the
Gear Housing Cover open or removed.
8. WEAR EYE PROTECTION! Everyday
eye glasses are not safety glasses.
Safety glasses conform to ANSI Z87.1
requirements. Note: Approved safety
glasses have Z87 printed or stamped on
them.
9. DO NOT use while under infl uence of
drugs or alcohol.
10. Household use only.
1. CHECK FOR DAMAGED PARTS.
Before using the Stuffer, check that all
parts are operating properly and perform
the intended functions. Check for binding
of moving parts, mounting and any other
conditions that may affect the operation.
2. KEEP CHILDREN AWAY. NEVER
LEAVE THE APPLIANCE UNATTENDED.
The Stuffer is NOT A TOY.
3. The Manufacturer declines any
responsibility in the case of improper use of
the Stuffer. Improper use of the Stuffer will
VOID the warranty.
4. NEVER store or leave the Stuffer at a
temperature lower than 32
o
F (0
o
C).
5. Repair must be done by an authorized
dealer. Use only factory original parts and
accessories. Modifi cation of the Stuffer will
VOID the warranty.
GEAR MOVEMENT
Fast Gear Shaft
With the Handle attached, turn
clockwise to raise the Plunger,
counter-clockwise
to lower the Plunger.
Slow Gear Shaft
With the Handle attached, turn
counter-clockwise to
raise the Plunger,
clockwise to lower the Plunger.