Data Sheet

o The devkit contains a carrier board, Azure Eye SoM, Azure Ear SoM, RGB camera,
accessories box with antennas and required cables, a section of 80/20 1010 Series
mounting rail, and a welcome card with a hex key.
o The welcome card includes a sticker that has two passwords needed to access the
dev kit's wifi access point. The first password is "santacruz" and is what should be
used with the dev kit out of the box. The second password is "scz-xxxx"
(where xxxx are the last four digits of the dev kit's MAC address), and will be
activated after you upgrade the dev kit to the latest OS version. DO NOT LOSE THIS
PASSWORD.
o The major components come mounted to the 80/20 rail out of the box, but they can
be removed or adjusted with the included hex key as desired.
2. Connect the devkit components:
[!NOTE] The power adapter port is located on the right side of the carrier board. The
remaining ports (2x USB-A, 1x USB-C, 1x HDMI, and 1x Ethernet) and the reset button are
located on the left side of the carrier board.
i. Hand screw both Wi-Fi antennas into the carrier board.
ii. Connect the Azure Eye SoM to the carrier board's USB-C port with the USB-C cable.
iii. Connect the Azure Ear SoM to the carrier board with the USB Micro Type-B to USB
Type-A cable. Connect the Micro Type-B end of the cable to the SoM and the Type-A
end to the carrier board.
iv. Connect the power cable to the power adapter.
v. Remove any remaining plastic packaging from the devices.
vi. Connect the power adapter/cable to the carrier board and a wall outlet. To fully
secure the power cable connector to the carrier board, use a P7 screwdriver (not
included in the devkit) to tighten the connector screws.