Realtek UWB BG13 HMC User Guide_revC.doc Realtek UWB BG13 HMC User Guide Revision C Author : Marco Chuang Date : 2009/02/10 1 All Rights Reserved by Realtek Corp.
Realtek UWB BG13 HMC User Guide_revC.doc Table of Contents 1. 2. Introduction.................................................................................................................... 3 System Description ........................................................................................................ 4 2.1. UWB PHY ............................................................................................... 5 2.2. 2.3. 3. 4. 5. 6. 7. UWB MAC..........................................
Realtek UWB BG13 HMC User Guide_revC.doc 1. Introduction This document describes the system, operations, and interfaces of the UWB BG1/3 HMC (half mini card) module. Two main applications are supported by this module. One is wireless USB application and the other one is WiNet mode. For WUSB application, the HMC is used as the host controller, and connect to wired USB device with a wireless DWA hub. WiNet mode is an IP-based network communication, and link up the networks by UWB module.
Realtek UWB BG13 HMC User Guide_revC.doc 2. System Description The UWB BG1 HMC module supports the following functions: Certified WUSB mode WiNet mode Support 53.3M, 80M, 106.7M, 160M, 200M, 320M, 400M, 480Mbps. Support BG1, BG3 and TFC1~TFC10 The module system mainly consists of two main chips – (i) UWB PHY(RTU7012), (ii) UWB MAC(RTU7305). A serial flash memory (2Mb) is required to store proper data/commands for the PHY chip and MAC chip.
Realtek UWB BG13 HMC User Guide_revC.doc 2.1.UWB PHY This chip integrates the RF and baseband functions of a UWB PHY defined by the standard. This version of PHY chip is packaged in 48-pin QFN form factor. The analog/RF section requires 1.5V and 3.3V to operate. The digital core operates with 1.2V and the I/O voltage can support a range of 3V~3.6V. 2.2.
Realtek UWB BG13 HMC User Guide_revC.doc 3. Hardware Interfaces 3.1. PCIe half mini card Interface Table 1 half mini card connector termination assignment 6 All Rights Reserved by Realtek Corp.
Realtek UWB BG13 HMC User Guide_revC.doc 4. Document History Date 2008/11/13 2009/02/10 Revision A C Description Initial Release Modify Author Marco Chuang Marco Chuang 5. Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance.
Realtek UWB BG13 HMC User Guide_revC.doc CAUTION: Any changes of modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. A UWB device operating under the provisions of this section shall transmit only when it is sending information to an associated receiver.
