User's Manual

Realtek UWB BG1 HMC User Guide_0411.doc

CAUTION: Any changes of modifications not expressly approved by

the grantee of this device could void the user’s authority to operate

the equipment.

7. Coordination Requirements

For real application, the transmitter will only be active when

communicating with the specific receiver through handshaking,

acknowledgement and other mechanisms over the wireless channel.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate

this equipment.

This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

A UWB device operating under the provisions of this section shall transmit

only when it is sending information to an associated receiver. The UWB

intentional radiator shall cease transmission within 10 seconds unless it

receives an acknowledgement from the associated receiver that its

transmission is being received. An acknowledgement of reception must