User's Manual

使用手冊

Flash should be loaded with proper content by using the Flash utility provided

by Realtek. A 64bit EEPROM and a SDRAM are required for DL160.

The RF performance can also be tested using the test utility provided by

RealTek. Two clock frequencies are used in the system – 66MHz for

RTU7105 and 24MHz for DL160. Some more details of the components are

shown in the following sections. The system block diagram is shown below.

Figure 1 System Block Diagram

Product Specification

Frequency Band 3168MHz ~ 4752MHz

Network Standard WiMedia PHY 1.1 & MAC 1.0. Support PHY 1.2

Modulation Mode Multiband OFDM with QPSK, DCM

FEC Coding Rate 1/3, 1/2, 5/8, 3/4 Convolutional Coding, Reed

Solomon Coding

Support Data Rate 8 data rates from 53.3Mbps to 480 Mbps

Interface VGA interface

Support Applications Certified WUSB

2.1. UWB PHY and MAC

This chip integrates the WiMedia PHY and MAC defined by the standard.

This version of chip is packaged in 64-pin

QFN form factor. The chip requires

1.5V, 1.32V and 3.3V for operation. High speed USB interface is supported.