Users Manual

The total radiated energy from the antennas connected to the installed wireless modules conforms to
the FCC limit of the SAR (Specific Absorption Rate) requirement, regarding 47 CFR Part 2 Section
1093, when the computer was tested in either conventional notebook or tablet computer orientations.
To know the location of transmission antennas for the Wireless LAN/Bluetooth combo module, see “Locate
the UltraConnect
™
wireless antennas” in the User Guide.
Simultaneous use of RF transmitters
Your computer is approved for simultaneous use of the integrated wireless LAN/Bluetooth combo module.
Make sure of the following conditions when you use any other external wireless option device:
• When you use any other RF option device, you are requested to confirm that the device conforms to the
RF Safety requirement and is approved to use for your computer.
• You must follow the RF Safety instructions of wireless option devices that are included in the user manual
of the RF option device.
• If wireless options are prohibited to use in conjunction with another transmitters, you must turn off all other
wireless features in your computer.
Radio Frequency interference requirements
When you use a wireless LAN module in the 802.11 a/n/ac/ax transmission mode, note that high power
radars are allocated as primary users of the 5250 to 5350 MHz and 5650 to 5850 MHz bands. These radar
stations can cause interference with and/or damage this device.
Canada — Industry Canada (IC)
IC certification number
Your computer contains the following wireless devices and the IC certification numbers are as below.
• IC: 1000M-9260NG
– Wireless LAN module with Bluetooth function (model: 9260NGW)
• IC: 1000M-8265NG
– Wireless LAN module with Bluetooth function (model: 8265NGW)
• IC: 1000M-AX200NG
–
Wireless LAN module with Bluetooth function (model: AX200NGW)
You can find the IC certification information through one of the following methods:
•
On a physical label attached to the outside of your computer shipping carton
• Through an electronic-label screen (E-label screen) preinstalled on your computer
To access the E-label screen, do one of the following:
• Restart the computer. When the logo screen is displayed, press F9. The E-label screen is displayed.
• Restart the computer. When the logo screen is displayed, press Enter or tap the prompt to enter the
Startup Interrupt menu. Then press F9 or tap the Regulatory Information option. The E-label screen is
displayed.
2
ThinkPad 11e Yoga Gen 6Regulatory Notice
• IC: 6317A-RTL8852AE
– Wireless LAN module with Bluetooth function (model:RTL8852AE)