User's Guide
The power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or
against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits
from the product.
WARNING! Do not operate this product with a damaged power cord set. If the power cord set is damaged in
any manner, replace it immediately. Damaged cords may result in user exposure to hazards.
Power cord notice
If you were not provided with a power cord for the computer or for an external power accessory intended for
use with the computer, you should purchase a power cord that is approved for use in your country or region.
The power cord must be rated for the product and for the voltage and current marked on the product's
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating marked on the product. In addition, the diameter of the wire must be a minimum of 0.75 mm²/
18AWG, and the length of the cord must be between 1.0 m (3.2 ft) and 2 m (6.56 ft). If you have questions
about the type of power cord to use, contact your authorized service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or
against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits
from the product.
DC plug of external HP power supply
The diagram illustrates the DC plug of external HP power supply.
Japan power cord notice
製品には、同梱された電源コードをお使い下さい。
同梱された電源コードは、他の製品では使用出来ません。
Japan power cord requirements
For use in Japan, use only the power cord received with this product.
CAUTION: Do not use the power cord received with this product on any other products.
Pinch hazard
Use this notice to warn about the possibility of pinching injuries.
WARNING! Observe pinch hazard areas. Keep ngers away from closing parts.
TV antenna connectors protection
Several safety notices might apply to TV antenna connectors.
External television antenna grounding
If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is
electrically grounded so as to provide some protection against voltage surges and built-up static charges.
18 Chapter 2 Safety notices