RTL8188CUS Slim Module Solo Card User’s Manual Rev. 1.0 15 Oct 2010 Realtek Semiconductor Corp. No. 2, Innovation Road II, Hsinchu Science Park, Hsinchu 300, Taiwan Tel.: +886-3-578-0211. Fax: +886-3-577-6047 www.realtek.com.
RTL8188CUS Slim Module Solo Card User Manual COPYRIGHT ©2009 Realtek Semiconductor Corp. All rights reserved. No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of Realtek Semiconductor Corp. DISCLAIMER Realtek provides this document “as is”, without warranty of any kind, neither expressed nor implied, including, but not limited to, the particular purpose.
RTL8188CUS Slim Module Solo Card User Manual Table of Contents 1. GENERAL DESCRIPTION................................................................................................................................................1 1.1. 2. RTL8188CUS .................................................................................................................................................................1 FEATURES......................................................................................
RTL8188CUS Slim Module Solo Card User Manual 1. General Description 1.1. RTL8188CUS The Realtek RTL8188CUS is a highly integrated single-chip Wireless LAN (WLAN) controller compatible with the IEEE 802.11n specification. It combines a MAC, a 1T1R capable baseband, and RF in a single chip. The RTL8188CUS provides a complete solution for a high-performance wireless client.
RTL8188CUS Slim Module Solo Card User Manual 2. Features 2.1.
RTL8188CUS Slim Module Solo Card User Manual Selectable digital transmit and receive FIR filters Programmable scaling in transmitter and receiver to trade quantization noise against increased probability of clipping Fast receiver Automatic Gain Control (AGC) On-chip ADC and DAC 28-ball 2.57 x 3.21x0.6mm 0.5mm pitch WLCSP Package , no underfill required Design optimized for low cost PCB manufacture. 3 Rev.1.
RTL8188CUS Slim Module Solo Card User Manual Product specifications 2.2. Connecter Pin Assignment Pin 1 2 3 4 5 6 7 8 9 10 Table 1. Connecter Pin Assignment Pin definition Type Description 3.3V P 3.3V DC Power Supply NC No connection NC No connection NC No connection GND G Ground USB D+ I/O USB D+ for WiFi’s USB2.0 USB DI/O USB D- for WiFi’s USB2.0 WiFi_Power_OFF I/O WiFi on: High; WiFi off: Low W_B_LED I/O/ LED is active low. GND G Ground 4 Rev.1.
RTL8188CUS Slim Module Solo Card User Manual 2.3. Mechanical Figure 1. RTL8188CUs Slim Module Mechanical Specification 5 Rev.1.
RTL8188CUS Slim Module Solo Card User Manual 2.4. Environmental 2.4.1. Operating Operating Temperature: Relative Humidity: 0 to 70 °C 5-90% (non-condensing) 2.4.2. Storage Temperature: Relevant Humidity: -55 to 125 °C 5-95% (non-condensing) 6 Rev.1.
RTL8188CUS Slim Module Solo Card User Manual 2.5. Functional Specifications Standards Bus Interface Form Factor Data Rate Media Access Control Modulation Techniques Network Architecture Operating Channel Frequency Range Security Operating Voltage Table 2. Functional Specifications WiFi: IEEE 802.11b, IEEE 802.11g, Draft IEEE 802.11n, IEEE 802.11d, IEEE 802.11e, IEEE 802.11h, IEEE 802.11i WiFi: USB Slim Module 6mm x 80mm 802.11b: 11, 5.5, 2, 1 Mbps; 802.11g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps 802.
RTL8188CUS Slim Module Solo Card User Manual 2.6. Warning 4.5.1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
RTL8188CUS Slim Module Solo Card User Manual IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
RTL8188CUS Slim Module Solo Card User Manual 4.5.2 Industry Canada Statement This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device This device has been designed to operate with an antenna having a maximum gain of 3.9dBi.
RTL8188CUS Slim Module Solo Card User Manual This RF module in the user’s manual of the end product which integrates this module. The user’s manual for OEM Integrators must include the following information in a prominent location “IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements. The antenna must not be co-located or operating in conjunction with any other antenna or transmitter”. 4.5.
