User's Manual
Table Of Contents
- RTL8187B_DataSheet_1.022.pdf
- RTL8187B_DataSheet_1.022.pdf
- RTL8187B_DataSheet_1.022.pdf
- General Description
- Features
- System Applications
- Block Diagram
- Pin Assignments
- Pin Descriptions
- CPU Access to Endpoint Data
- USB Request
- Get Descriptor-Device
- Get Descriptor-Device Qualifier (High Speed)
- Get Descriptor-Configuration
- Get Descriptor-String Index 0
- Get Descriptor-String Index 1
- Get Descriptor-String Index 2
- Get Descriptor-String Index 3
- Get Descriptor-String Index 4
- Get Descriptor-String Index 5
- Get Descriptor-Other Speed Configuration
- Set Address
- Set Interface 0
- Set Feature Device
- Clear Feature Device
- Set Config 0
- Set Config 1
- EEPROM (93C46 or 93C56) Contents
- USB Packet Buffering
- Functional Description
- Application Diagram
- Electrical Characteristics
- Mechanical Dimensions
- Ordering Information
- SGS Test Report
- RTL8187L manual1.pdf
- RTL8187B_DataSheet_1.022.pdf
- RTL8187B_DataSheet_1.022.pdf
IC Radiation Exposure Statement:
"Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device."
Without Co-located
The antenna (s) used for this transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
Modular OEM Integrator Notice
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users. The final end product must be labeled
in a visible area with the following: "Contains TX IC: 6317A-RTL8187B"