Replacement Part List

-7-
the high-pressure connection no
longer contains any bubbles.
 Switch off the machine at the main
switch(4) and screw the
high-pressure hose (6) back on.
9.4 Cleaning Method
1. Spray the detergent sparingly on to
the dry surface. Allow it to act for a
short time without letting the
detergent dry.
2. Rinse off the loosened dirt with the
high-pressure jet.
9.5 Water Loss
It is normal for the pump to lose small
quantities of water. If there is a
sizeable leak, please contact our
service department.
9.6 Protection against Damage
Please do not underestimate the
pressure produced by the electric
pressure washer. If you would like to
clean sensitive surfaces it is better to
use the fan jet.
In the case of paints or insulated
facades please begin at a considerable
distance away. Move slowly close
depending on the degree of soiling –to
the object to be cleaned. Check the
progress of you work at short intervals
in order to prevent damage.
NOTE: Never point the high pressure
jet at other people, animals, the device
itself or electrical equipment!
10. AFTER USE INSTRUCTIONS
The machine should be stored in a
frost-free room!
Pump, hose and accessories should
always be emptied of water prior to
storing as follows:
1. Stop the machine (press the
start/stop switch (4) “O” and detach
water hose, high pressure hose (6) and
nozzle (10-15).
2. Restart the machine (4) and activate
the trigger of the trigger gun (7). Let
the machine run until no more water
runs through the trigger gun (7)
3. Stop the machine, unplug and wind
up hose and cable.
Should the machine by mistake be
frozen, it will be necessary to check it
for damage.
WARNING: Never start up a frozen
machine. Frost damages are not
covered by the guarantee!
WARNING: Always disconnect the
electrical plug from the socket prior to
maintenance or cleaning.
To ensure a long and problem free
working life, please take the following
advice:
 Wash out water hose, high pressure
hose, spray lance and accessories
before mounting.
 Clean the connectors of dust and
sand.
 Rinse the detergent spraying
attachment after use.
 Clean the nozzles.
Any repair should always be made in an
authorized workshop with original spare
parts.
11. MAINTENANCE, CLEANING AND
REPAIR
EN