High-Pressure Washer Model No.:BCMH CAUTION : Do not use this device before reading the instructions.
1. Safety Instructions The appliance has been designed solely for private use outdoors and not for commercial use. Keep this appliance away from heat, direct sunlight, moisture and rain, ice and sharp edges. Do not allow anybody that has not been trained to use a pressure washer to operate the machine without first reading the instruction manual. WARNING: High-pressure washers must not be used by children or untrained persons. Before starting your machine, carefully check for defects.
detergent. Using other cleaning products or chemical products may affect the safety of the appliance. WARNING: Disconnect the appliance from the power supply before carrying out any maintenance. CAUTION: To ensure the safety of the appliance, only use spare parts supplied or approved by the manufacturer. Do not use the appliance if the power cable or important parts of the appliance are damaged, for example, the safety device, high pressure hose and handgun.
4 manufacturer, their service agent or a qualified professional in order to avoid any danger. WARNING: This machine is not designed to be used by persons (including children) with reduced physical, sensory or mental capacities or whose lack experience or knowledge. WARNING: It is advisable that you supervise children to ensure that they do not play with the appliance. CAUTION – Risk of explosion – do not spray flammable liquids, do not direct the jet towards flammable liquids.
Connecting the electrical connection should be done by a qualified electrician conforming to 60364-1 CEI It is recommended that the electrical supply to this machine should comprise a residual current device which interrupts the current if the leakage current exceeds 30 mA for 30ms.
Thank you for choosing the BCMH High-Pressure Washer The Circuitry Contents Chapter 1. Safety Instructions 2. Getting Started 3. Operating your pressure washer 4. End of operation instructions 5. Environmental protection 6. Maintenance, cleaning and repairing. 7. Breakdown service 8. WEEE - Waste of Electric and Electronic Equipment Page 2 7 7 9 9 9 11 12 Technical data Motor Max. pressure Max flow Current Voltage Water temperature Brush 2300PSI 1.75GPM 14.50A 120V~/60Hz 40℃ Contents 1.
2. First time instructions This section will explain in details how to make high pressure washer ready for use. SAFETY DEVICES The unloader valve can reduce pressure if it exceeds pre-set values. Locking device on trigger gun (see illustration at the beginning of this manual): The trigger gun features a locking device. When the knob is activated, the trigger gun cannot be operated. Connect the garden hose with a standard quick coupling 1 A 3.
EN 2 A 1 3 Attention: All accessories nozzle can be installed as above instruction. 3.4 Water connection Connecting the water supply pipe Follow your water supplier’s instructions . For connection information, see the data plate/technical specifications Use a reinforced hose (not supplied) with a standard connection (ext. diameter: 16mm/int. 12mm, maximum length: 25m). IMPORTANT! Only use water without any impurities. If there is a risk of sand particles in the inlet water (i.e.
3.7 Use of built-in detergent bottle Open the lid in the back side of the pressure washer, add detergent to the bottle, replace the nozzle of the spray gun to the detergent nozzle as below, turn the pressure washer on, then spray detergent by pulling the gun trigger. 3.8 Mounting of Patio Cleaner 1. Insert the extension lance into to the housing 2. Fix the extension lance with the two screws to the housing 3. Insert the rotor arm into the extension lance 4. Insert the U-pin to fix the rotor arm.
The machine should be stored in a frost-free room! Pump, hose and accessories should always be emptied of water prior to storing as follows: Stop the machine (press the start/stop switch “O” and detach water hose, high pressure hose and nozzle Restart the machine and activate the trigger of the trigger gun Let the machine run until no more water runs through the trigger gun Stop the machine, unplug and wind up hose and cable.
7. Breakdown service Symptom Cause The machine will not The machine is not plugged-in start Faulty receptacle Fluctuating pressure The machine stops Recommended action Plug the machine in Try another receptacle The fuse has blown Replace the fuse Unplug other appliances Faulty extension cable Try without the extension cable The pump is drawing in air Check that hoses and connections are airtight.
WEEE - Waste of Electric and Electronic Equipment The symbol on the product or on its packing indicates that this product may not be treated as household waste. Instead it shall be handed over. To the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
