Replacement Part List

An ordinary 1/2" garden hose of min.
10 m and max. 25 m will be suitable.
IMPORTANT! Only use water without
any impurities. If there is a risk of sand
particles in the inlet water (i.e. from
your own well), an additional filter
should be mounted.
1. Let the water run through the
water hose before connecting it to
the machine to prevent sand and
dirt from penetrating the machine.
Note: Check that the filter is fitted
in the water inlet pipe and that it is
not clogged up.
2. Connect the water hose to the
water supply by means of the quick
connector (inlet water, max.
pressure: 10 bar, max. temperature:
40°C).
3. Turn on the water.
The trigger gun (11) and lance (15) is
affected by a thrust during operation -
therefore always hold it firmly with
both hands.
IMPORTANT: Point the nozzle at the
ground.
1. Check that the machine is in
upright position. NOTE: Do not
place the machine in high grass!
2. Release the trigger lock (12)
3. Activate the trigger of the trigger
gun (11) and let the water run until
all air has escaped from the water
hose.
4. Press the Start/stop switch (5).
5. Activate the trigger of the trigger
gun (11).
6. Always adjust the distance and thus
the pressure of the nozzle to the
surface, which is to be cleaned.
Do not cover the machine during
operation or use it in a room without
adequate ventilation!
NOTE: If the machine is left or not
used for 5 minutes, it must be
switched off on the start/stop switch
(5) "O":
1. Press the start/stop switch (5) "O".
2. Disconnect the electrical plug (2)
from the socket.
3. Shut off the water supply and
activate the trigger of the trigger
gun (11) to relieve the machine of
pressure.
4. Lock the trigger gun (11)
When releasing the trigger of the
trigger gun (11), the machine
automatically stops. The machine will
start again when you re- activate the
trigger gun (11)
The pressure can for the multi nozzle
(16) be adjusted by tuning it.
WARNING: Do not do this under
operation to avoid that the hand hits
the jet.
9
EN