Replacement Part List
WARNING: Inadequate extension
cables can be dangerous. Cables on
reels should always be completely
unwinded to prevent the cable from
overheating.
WARNING: Inadequate extension
cords can be dangerous.
If an extension cable is used, the
plug and the socket must be
waterproof and comply with the
below-mentioned requirements for
length and cable dimensions.
1.0 mm² max. 12.5 m
1.5 mm² max. 20 m
If the electric cable is damaged, it
must be replaced by the
manufacturer or his service agent
or similarly qualified person in
order to avoid a hazard.
MAINS POWER CONNECTION
The following should be observed when
connecting the high pressure washer to
the electric installation:
The electric supply connection shall
be made by a qualified electrician
and comply with IEC 60364-1
It is recommended that the electric
supply to this appliance should
include either a residual current
device that will interrupt the supply
if the leakage current to earth
exceeds 30 mA for 30 ms.
WATER CONNECTION
Connection to the public mains
according to regulations.
Inlet hose can be connected to the
water mains with a max. inlet
pressure of 10 bars.
This high pressure washer is in Europe
only allowed to be
connected with the drinking
water mains, when an
appropriate mains backflow preventer
has been installed, Type BA according
to EN 1717. The length of the hose
between the backflow preventer and
the high pressure washer must be at
least 10 metres to absorb possible
pressure peaks (min diameter ½ inch).
Operation by suction (for example
from a rainwater vessel) is carried out
without backflow preventer.
As soon as water has flown through the
BA valve, this water is not considered
to be drinking water any more.
IMPORTANT!
Only use water without any impurities.
If there is a risk of sand particles in the
inlet water (i.e. from your own well),
an additional filter should be mounted.
SAFETY DEVICES
The unloader valve can reduce
pressure if it exceeds pre-set values.
Locking device on trigger gun (12) (see
illustration at the beginning of this
manual): The trigger gun (11) features
a locking device (12). When the knob is
activated, the trigger gun (11) cannot
be operated.
THERMAL SENSOR
A thermal sensor protects the motor
against overloading. The machine will
restart after a few minutes when the
thermal sensor has cooled.
6
EN