Replacement Part List

Machine refuses to
start
Fluctuating
pressure
Machine not plugged in Plug in machine.
Defective socket Try another socket.
Fuse has blown Replace fuse. Switch off other machines.
Defective extension cable Try without the extension cable.
Pump is sucking air Check that hoses and connections are
airtight.
Valves dirty, worn out or
stuck
Contact your nearest service centre
Water supply not sufficient Increase water pressure, check for
blockage of garden hose and/or change to
bigger hose.
Pump seals worn Contact your nearest service centre
Machine stops Fuse has blown Replace fuse. Switch off other machines.
Incorrect mains voltage Check that the mains voltage corresponds
to specification on the name plate
Thermal sensor activated Leave the machine for 5 minutes to cool
down
Nozzle partially blocked Clean the nozzle with a needle and by
spraying water backwards through the
nozzle
Fuse blows Fuse too small Change to an installation higher than the
amperage consumption of the machine.
Amperage increase Try without the extension cable.
Machine pulsating Air in inlet hose/pump Allow machine to run with open trigger
until regular working pressure resumes.
Inadequate supply of mains
water specifications
required
Increase water pressure, check for
blockage of garden hose and/or change to
bigger hose.
Nozzle partially blocked Clean the nozzle with a needle and by
spraying water backwards through the
nozzle
Water filter blocked Clean the filter
Hose kinked Straighten out hose.
Machine often
starts and stops by
Pump and/or trigger gun is
leaking
Contact your nearest service centre
itself No water supply Connect inlet water.
Machine starts but
no water comes
out
Water filter blocked Clean the filter
Nozzle blocked Clean the nozzle with a needle and by
spraying water backwards through the
nozzle
13
EN
S m t m mm n ti n