Specifications

Real Tone Technology Co., Lted www.realtonetech.com
Page 38/67
2.5
Line Configuration
2.5.1 FXS or FXO Phone Number
After login, click “Line > FXS phone number” tab or “Line > FXO phone number” tab to open the
configuration interface.
Figure 2-9 Configuration Interface for Telephone Number
Table 2-12 Configuration Parameters of Telephone Number
Name Description
FXS 1st line No. This number is used for the batch setup of consecutive number of
subscriber line. Click “Batch ”after filling in initial number, the number
of Line 1 adopts initial number; that of Line 2 increases 1 progressively
based on that of Line 1, and so on. You needn’t fill in if you do not use
batch configuration or the number is not consecutive.
ID n Fill in the telephone number associated with the subscriber line n (FXS
port). This should be manually perform if Batch mode is not used.
FXO 1st line No. This number is used for the fast setup of consecutive number of trunk
line. Click "Batch " after filling in initial number, the number of Line 1
adopts initial number; that of Line 2 increases 1 progressively based on
that of Line 1, and so on. You needn’t fill in if you do not use batch
configuration or the number is not consecutive.
ID n Fill in the telephone number associated with the trunk n (FXO port).
This should be manually perform if Batch mode is not used.
2.5.2 Subscriber Line Features
This page is only used for configuring gateways with subscriber lines (FXS port).