Specifications

Real Tone Technology Co., Lted www.realtonetech.com
Page 24/67
Table 2-3 Network Configuration Parameters
Name Description
Host name This is the equipment name of a configuration gateway. The default values
of WSS8, WSS50, WSS100 and WSS120 are WSS8-VoIP-AG,
WSS50-VoIP-AG, WSS100-VoIP-AG and WSS120-VoIP-AG respectively.
Users can set a different name for each gateway to distinguish from each
other according to the deployment plan.
A host name can be a maximum of 48 characters, either letters (A-Z or a-z),
numbers (0-9) and minus sign (-). It may not be null or space, and it must
start with a letter.
Logical IP
address
This parameter only exists in WSS100, used to display the actual gateway
IP address in use.
ETHn
MAC address Display the MAC address of gateway.
IP address
assignment
Methods for obtaining an IP address
l Fixed: Static IP address is used;
l DHCP: Activate DHCP service and use the dynamic host configuration
protocol (DHCP) to allocate IP addresses and other network parameters;
l PPPoE: PPPoE service is used.
User name Enter an authentication user name if PPPoE service is selected, and there is
no default value.
Password Enter an authentication password if PPPoE service is selected, and there is
no default value.
IP address If “Static” or “DHCP” is selected for the network type but an address fails
to be obtained, the gateways will use the IP address filled in here. If the
gateways obtain an IP address through DHCP, the system will display the
current IP address automatically obtained from DHCP by the gateways.
This parameter must be set due to no default value.
Netmask The subnet mask is used with an IP address. When the gateways use a static
IP address, this parameter must be entered; when an IP address is
automatically obtained through DHCP, the system will display the subnet
mask automatically obtained by DHCP. This parameter must be set due to
no default value.
Gateway IP
address
LAN gateway IP address where the gateways are located. When the
gateways obtain an IP address through DHCP, the system will display the
LAN gateway address automatically obtained through DHCP. This
parameter must be set due to no default value.
DNS
Enable Activate DNS service.
Primary Server If DNS service is activated, the network IP address of preferred DNS server
must be entered, and there is no default value.
Secondary
Server
If DNS service is activated, the network IP address of standby DNS server
can be entered here. It is optional and there is no default value.
SNTP
Primary Server Enter the IP address of preferred time server here. This parameter must be
set due to no default value.
Secondary
Server
Enter the IP address of standby time server here. This parameter must be set
due to no default value.