Specifications
Real Tone Technology Co., Lted www.realtonetech.com
Page 21/67
2 Parameter Setting
2.1
Login
2.1.1 Obtain Gateway IP Address
WSS8 and WSS50 Gateways start DHCP service by default, and automatically obtain an IP address
on the LAN; users can use the factory default gateway IP address if it is unable to be obtained (e.g.
when connected directly with a computer).
WSS100 and WSS120 Gateways use a static IP address by default.
Table 2-1 Default IP Address of Gateway
Type Default DHCP Service Default IP Address Default Subnet Mask
WSS8 Enabled 192.168.2.218 255.255.0.0
WSS50 Enabled 192.168.2.228 255.255.0.0
WSS100 Disabled 192.168.2.240 255.255.0.0
WSS120 Diasabled 192.168.2.240 255.255.0.0
l
DHCP Used in Network
Users can dial "# #”to obtain the current gateway IP address and version information of firmware
using the telephone connected to the subscriber line (FXS interface) after the equipment is
powered on.
If the gateways are only configured with FXO ports for analog trunks without FXS ports for
subscriber lines (e.g. WSS8-4FXO or WSS50-24FXO), users can dial into the gateway by
connecting a PBX extension line or PSTN POTS line to a FXO port, and press "# #" to obtaining
the current gateway IP address and version information of firmware after receiving the second
dial tone.
l
Fixed IP Address Used
Ø If the DHCP service on the network is not available or the gateway is directly connected
with a computer, the gateways will use the factory default IP address.
Ø A user could fail to log in with the default IP address if the IP address of user’s computer
and the default gateway IP address are not at the same network segment. It is recommended
that the IP address of user's computer is changed to be identical with the same network
segment of gateway. For example, if the gateway IP address is 192.168.2.240, it is
recommended to set the computer’s IP address to any address at the network segment of
192.168.2.XXX).
l
PPPoE Used
In “Basic Configuration> Network Configuration”, the gateways will automatically obtain the
WAN address returned by access network after PPPoE service is started and user name and
password are set. Users can dial “# #”on the gateways to receive the IP address and version
information of firmware the gateways has obtained.