User`s guide

Monitors and Cameras
Polycom, Inc. 3–11
4 Near site, full screen
5 Far site, full screen
The last layout viewed is used for the next call.
Configuring Multipoint Viewing Modes
To configure multipoint viewing modes:
1 Do one of the following:
— In the local interface, go to System > Admin Settings > Monitors >
Multipoint Setup.
— In the web interface, go to Admin Settings > Monitors > Multipoint
Setup.
2 Configure this setting:
What you see during a multipoint call can depend on factors such as the
Polycom HDX system monitor configuration, the number of sites in the call,
the speed of the call, whether content is shared, and whether dual monitor
emulation is used. The multipoint viewing mode on the host system is the
mode used in the call.
Setting Description
Multipoint Mode Video images from multiple sites can be automatically
combined on one screen in a display know as continuous
presence.
Auto — The view switches between continuous
presence and full screen, depending on the
interaction between the sites.
If multiple sites are talking at the same time,
continuous presence is used. If one site speaks
uninterrupted for at least 15 seconds, that site appears in
presentation mode.
Discussion — Multiple sites are displayed in
continuous presence. The current speaker’s
image is highlighted.
Presentation — The speaker sees continuous
presence while the other sites see the speaker in
full screen.
Full Screen — The site that is speaking is
shown in full screen to all other sites. The current
speaker sees the previous speaker.