User`s guide

Control Devices
Polycom, Inc. 10–7
— If your network connection to the Polycom Touch Control does not
provide PoE, you must connect the Ethernet cable to the power supply
adapter. Then connect the power supply adapter to a LAN outlet and
power outlet. Be sure to plug the male end into a LAN outlet in the
wall.
The Polycom Touch Control powers on and displays the language
selection screen.
6 Choose your language and follow the onscreen instructions to pair the
Polycom Touch Control with your HDX system, or select Pair Later on
the Pairing screen to skip pairing.
7 After the Polycom Touch Control connects to the network, enter the HDX
system IP address and touch Connect. By default, the IP address of the
HDX system is displayed on the bottom of its Home screen. If the HDX
system is configured to allow pairing and you enter the IP address for the
system correctly, the Touch Control displays a prompt for the Polycom
HDX system admin user ID and password.
When the Polycom Touch Control has paired and connected with the HDX
system, the Polycom Touch Control displays a success message, and the
menus on the HDX system monitor become unavailable. For more
information about pairing, refer to Pairing on page 10-8.
Pairing and Unpairing a Polycom Touch Control Device
and a Polycom HDX System
When you configure the Polycom Touch Control to pair with a particular
Polycom HDX system, the Polycom Touch Control makes an IP connection to
the HDX system. If the connection is lost for any reason, the Polycom Touch
Control automatically attempts to restore the connection.
The Polycom Touch Control connects to the HDX system over a TLS socket,
providing a reliable, secure communication channel between the two systems.
The Polycom Touch Control initiates all pairing connections and attaches to
port 4122 on the HDX system.
You can pair the Polycom Touch Control and Polycom HDX system during
initial Polycom Touch Control setup, as described in the steps on the previous
page.
After you have completed Polycom Touch Control setup, you can pair to a
different HDX system using Polycom Touch Control settings and unpair using
the web interface. Refer to Pairing on page 10-8 for more information.
The Polycom Touch Control is supported with the SoundStation IP 7000 phone
when both are connected to an HDX system.