User`s guide

Administrator’s Guide for Polycom HDX Systems
10–6 Polycom, Inc.
3 For a Polycom HDX 9004, select if necessary, and configure the
settings for port 2.
Setting Up the Polycom Touch Control Device
The Polycom Touch Control allows you to control a Polycom HDX system.
Follow these steps to get started with the Polycom Touch Control. Refer to the
Setting Up the Polycom Touch Control and Installing Software and Options for
Polycom HDX Systems and Accessories documents for more information.
To set up the Polycom Touch Control Device:
1 Ensure that the correct software is installed on the Polycom HDX system
that you want to control, and that you have completed the setup wizard
on the HDX system.
Refer to Installing Software and Options for Polycom HDX Systems and
Accessories for more information about updating the Polycom Touch
Control software.
2 Connect the Ethernet cable to the underside of the Polycom Touch
Control.
3 If you intend to use the Polycom Touch Control to show content from a
computer, connect the USB cable to the underside of the Polycom Touch
Control.
4 If you want to connect the stand, route the Ethernet and USB cables
through the opening in the stand. Then attach the stand to the Polycom
Touch Control by tightening the mounting screw with a screwdriver.
5 Plug the Ethernet cable into the wall outlet:
— If your network connection to the Polycom Touch Control provides
Power over Ethernet (PoE), you can connect the Ethernet cable
directly to the LAN outlet.
RS-232 Flow
Control
When a Vortex is connected to an RS-232 connector on
the Polycom HDX system, set both to Hardware. This is
selectable when RS-232 Mode is set to Vortex Mixer or
Pass Thru.
Camera Control Specifies which camera to control when RS-232 Mode is
set to Camera PTZ.
Detect Camera Detects the camera specified for Camera Control.
Setting Description