User`s guide

Administrator’s Guide for Polycom HDX Systems
5–4 Polycom, Inc.
When you connect to video and audio from your computer, the audio is muted
unless the computer is selected as a video source.
For more information about connecting computers as content video sources
for Polycom HDX systems, refer to Connecting Cameras on page 3-14. Refer to
your system’s setup sheet for connection details.
Configuring Content Sharing
To configure the content display:
1 Do one of the following:
— In the local interface, go to System > Admin Settings > Monitors >
Monitors (select if necessary).
— In the web interface, go to Admin Settings > Monitors.
2 Select Display Content for the monitor that will display content (not
available on the Polycom HDX 6000 series).
3 Do one of the following:
— In the local interface, go to System > Admin Settings > Network >
Call Preference (select if necessary).
— In the web interface, go to Admin Settings > Network > Call
Preference.
4 Enable H.239.
Points to note about sending content from Polycom HDX systems:
• The maximum resolution for sending content for HDX 7000 with Hardware
Version C or D and HDX 8000 with Hardware Version A systems is 720p. If you
connect a computer to video input 4, the maximum resolution you can set is
1680 x 1050, which is WSXGA, but the HDX 8000 system’s maximum encode
resolution is 1280 x 1024, which is SXGA.
• The maximum resolution for sending content for HDX 8000 with Hardware
Version B and HDX 9006 systems is 1080p. However, if you use video input 2
for the camera, you will be able to send content at a maximum of only 720p for
content. If you connect a computer to video input 4, the maximum resolution you
can set is 1920 x 1200, but the HDX 8000 system’s maximum encode resolution
is 1920 x 1080.
You cannot enable or disable H.239 while in a call.