User`s manual

User’s Manual
GSM35 15 RTD Finland Oy
Chapter 3
B
OARD INSTALLATION
The GSM35 GSM modem module is designed to directly mount on top or
under your RTD PC/104 cpuModule stack. This chapter tells you step-by-
step how to install your GSM35 into your system.
Board installation
Keep your board in its antistatic bag until you are ready to install it to your
system! When removing it from the bag, hold the board at the edges and
do not touch the components or connectors. Please handle the board in
an antistatic environment and use a
grounded
workbench for testing and
handling of your hardware. Before installing the board in your computer,
check the power cabling. Failure to do so may cause the power supply
unit to malfunction or even cause permanent damage.
General installation guidelines:
•
Touch the grounded metal housing of your computer to discharge any
antistatic buildup and then remove the board from its antistatic bag.
•
Hold the board by the edges and install it in an enclosure or place it on
the table on an antistatic surface
•
Install your board in your system, and wire the power supply correctly.
Failure to do so may cause the power supply unit to malfunction or
even cause permanent damage to the device.
•
Check all wiring connections once and then once more again
•
Connect the SIM card and the GSM antenna to the OSX connector on
the GSM35 board
•
Apply power to your system