User guide

String Mapping – Explanation
Below are the different parts that can be modified to make up a string mapping.
String data types can only be mapped to other string data types. There is no manipulation that can be
done on the string.
1. Enable (red box above): Check to enable mapping. If not checked, this mapping is skipped.
2. Source Field (yellow box above) :
a. Group - Select the string data group you set up in the protocol config to use for this
mapping.
b. String - This is the string used for this mapping.
3. Destination Field (green box above):
a. Group - Select the string data group you set up in the protocol config to use for this
mapping.
b. String - This is the string where the data is being stored.
Real Time Automation, Inc. 34 1-800-249-1612