Installation Guide
Installation Instructions
RN215EFS_B_Tbl&UtilyTray_0213
© 2013 Knape & Vogt Manufacturing Company. All rights reserved.
Inspect all parts and read all instructions prior to beginning assembly and installation.
Step 1 Measure inside dimensions of the drawer
into which the insert will fit. Subtract 1/16”
from the width and depth.
Step 2 Transfer the dimensions to the insert. Trim
length and depth, cutting at a low angle.
Smooth any rough edges by using
sandpaper along the edges.
Step 3 Place insert in drawer. Installation is now
complete.
Parts Included
A. Tray
• Tape Measure
• Handsaw or Utility Knife
• Sandpaper
• Pencil
TW-850
TW-1217
TW-1517
TW-1817
UT-1217
UT-1517
UT-1817
DEPTH
WIDTH
step 1
step 2
step 3
DEPTH
WIDTH
CUT 1/6” LESS THAN DEPTH
CUT 1/6” LESS THAN WIDTH
CUT BACK ONLY
KNAPE & VOGT MANUFACTURING COMPANY
2700 Oak Industrial Drive NE • Grand Rapids, MI 49505
800.253.1561 • www.kv.com