Installation Guide

TWO-TIEREDDRAWERORGANIZER
Installation Instructions
Parts Included
A. Tray Assembly
B. (2) #8x1/2" woodscrews
ToolsRequired
• Phillips screwdriver
• Pliers or 5/16 wrench
• Straight edge
• Utility knife
• Sabre saw or coping saw
• Table saw (optional)
ProductAssemblies
1475E
1775E
2075E
Inspect all parts and read all instructions prior to beginning assembly and installation.
Measure interior width of drawer and
subtract 1/16" from this dimension.
Invert bottom tray and mark equal cuts
from each wing to the dimension above.
Cutting can be done with a straight edge
and utility knife. Care should be taken to
make parallel cuts from each wing.
Optional step: cutting can be done on a
table saw.
Remove drawer from cabinet. Using a
sabre saw and eye protection, remove
the top portion of the back of the cabinet
drawer so that it is no more than 1" high.
Place lower tray inside the drawer,
setting the flat end with the two small
holes against the front of the drawer.
Attach the lower tray to the drawer
using the two screws provided. Place the
top tier into the lower tray and replace
the drawer into the cabinet opening.
Clearance Notes:
TrayLength: It is permissible for the front-to-back length of the tray to extend beyond
the lowered back of the drawer, therefore making use of the void space between the
drawer and the cabinet back. It is possible to trim the length of the lower tray from
19-1/4" to 18-3/8" if necessary.
Drawer Height: In the event that the sides of the drawer are less than 3" high, it is
permissible for the side wings of the lower tray to sit above the drawer sides.
Drawer Width: In the event that the interior drawer width is wider than the insert, it is
recommended that the insert be installed either to the far right or left, and a permanent
front to-back drawer partition be positioned against the open insert side, creating
another storage pocket.
1”
[25.4mm]
A
B
Step 1
Step 2
Step 3
1
2
3
RN211EFS_B_2TierDwrOrgnzr_0213
© 2013 Knape & Vogt Manufacturing Company. All rights reserved. Made in USA.
KNAPE & VOGT MANUFACTURING COMPANY
2700 Oak Industrial Drive NE • Grand Rapids, MI 49505
800.253.1561 • www.kv.com