Installation Guide

TOWEL BAR
Installation Instructions
KNAPE & VOGT MANUFACTURING COMPANY
P. O. Box 191, Muncie, IN 47308
0.899.6535 • 765.288.8730 • Fax [phone] • www.kv.com
RN-236EFS 03/03
Inspect all parts and read all instructions prior to beginning assembly and installation.
Parts Included
A. Wire Towel Bar
B. Two Mounting Screws
Tools Required
• Phillips Screwdriver
• Drill with 1/16” bit for pilot holes
•Pencil
Product Assemblies
TB-1-W
TB-1-A
TB-W
TB-A
TB-C
Step 1 Place towel bar in desired
mounting location.
Step 2 Use pencil to mark the screw
location onto the mounting
surface. Note: To avoid splitting
the wood it is recommended to
drill pilot holes.
Step 3 Make sure the thickness of the
material is greater than the length
of the screws. Fasten into place
with the two mounting screws
provided. Note: Do not over-
tighten as that may strip screw
threads in wood. Installation is
now complete.
A
B
Step 1
Step 2
Step 3