Spec Sheet 1

GLASS / GEMS PLACEMENT

Separator

screen

Burner pan

Fig. 8-1

Granules

up to bafﬂ e

(Pack granules in pan)

BURNER PREPARATION

After hooking up the burner to the ﬁ replace gas supply and placing

the heat shield on the valve assembly (if applicable), the decorative

media (granules and glass / gems) must be added for the burner

to function as designed.

Note: Installation is the same for glass and gems. Glass

shown here. These instructions show sand granules

being used as a base for the glass, but only natural-gas

burners use sand. For propane burners, follow these

instructions using vermiculite.

WARNING

The burner and pilot (if equipped) must be OFF (fully extinguished),

and all valve covers must be in place before pouring media onto

the burner. It may also be necessary to temporarily cover the pilot

assembly (if equipped) to keep media out of it during this procedure.

GRANULE PLACEMENT

Pour the granules into the pan, just below level of the center ﬂ ame

bafﬂ e. Then pack the granules into the pan. Add additional granules

as needed (see Fig. 8-1).

GLASS / GEMS PLACEMENT

CAUTION: Glass pieces may have sharp edges. Be careful handling

the glass. Use hand protection, such as gloves, if

necessary.

1. Pour the glass / gems directly on top of the burner pan so that

the burner pan is covered completely and evenly (see Fig. 8-2).

DO NOT exceed a 1" depth of glass directly above the burner

pan.

Note: At this stage the burner will function as designed; however,

more glass / gems may be added around the burner for

decorative purposes.

2. Add additional glass / gems around the burner pan as

desired (Fig. 8-3).

Fig. 8-2

Fig. 8-3