Spec Sheet 1

ManualsBrandsReal Fyre ManualsFireplace/Gas Stove AccessoriesVented Collection PB-24-15M 24" Pan Burner with Flat Burner Pan Provides Full Flame, Connector Kit and Damper Clamp in Black

INSTALLATION

The damper clamp with hex bolt (Fig. 14-1) is provided as a means to

prevent full closure of the damper blade. The clamp is easily attached to most

damper blades with pliers or a wrench, and must be permanently installed.

The clamp is designed to prevent accidental closure of the damper when

installed as illustrated (

Fig. 14-2 and Fig. 14-3). Should the clamp not ﬁ t, or

fail to provide the permanent vent opening listed in the table found above,

have a permanent stop installed, remove the damper

blade, or have the damper cut to provide the minimum

permanent opening required.

Note: These are minimum damper opening

speciﬁ cations. The damper must be completely

opened when operating this gas appliance to

achieve the best ventilation possible.

INSTALLING THE BURNER

The Real Fyre gas burner system must be installed by a qualiﬁ ed professional service technician. Instructions

must be followed carefully to ensure proper performance and full beneﬁ t from the gas burner system. Check to

be sure the burner system is designed and labeled for the type of gas (natural or propane gas) supplied

to the ﬁ replace. Fireplace ﬂ oor must be level, clean, and smooth.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts

speciﬁ cally approved with this appliance may result in property damage or personal injury.

REFER TO THE PARTS LIST WHEN FOLLOWING THESE INSTRUCTIONS.

1. MAKE SURE THE FIREPLACE GAS SUPPLY IS TURNED OFF.

2. Locate the gas-supply stub inside the ﬁ replace and remove the cap, if attached (see Fig. 14-4).

CAUTION: When removing the cap, make sure the stub does not turn, loosening the connection inside the wall.

3. Attach the nut end of the ﬂ ex connector (Item 4) to the adapter found on the valve or, if attached, on the

regulator behind the valve. Tighten securely.

4. Place the burner system into the ﬁ replace so that it is centered and the open burner pan faces outward.

5. Be sure gas to the ﬁ replace is off. Attach the large adapter end of the ﬂ ex connector (Item 4) to the gas-supply

stub using a pipe compound resistant to all gases. Ensure adapter (and nut) are tightened securely. Ensure

the pan rests level on the ﬁ replace ﬂ oor after connection. Adjust the pan if necessary.

6. LEAK TEST: Turn on the ﬁ replace gas supply, and test at all connections for leaks using the appropriate soapy

water solution. If bubbles appear, a leak is present. Turn off the gas and tighten at all connections. Repeat

until no leaks are present. If a leak persists, turn off the gas supply and contact the local gas company or

dealer. NEVER USE A FLAME TO CHECK FOR LEAKS.

Turn off the gas supply prior to proceeding.

7. Place the heat shield over the regulator and/or valve.

Important: Heat shields must be in place during operation

of the gas burner system. Overheating of the

valve will cause shut down of the gas burner

system or other operating problems.

8. If this unit was shipped with a remote, read and follow the

separate remote instructions (packed with remote) for

complete remote installation.

Fig. 14-1

Damper clamp

Set screw

Fig. 14-2 Fig. 14-3

Open

Closed

4. Place the burner system into the ﬁ replace so that it is centered.

Fig. 14-4

Gas supply

line stub

Gas line

cap