Spec Sheet 1

8
L-A2-376
Rev 1 - 1904120815
INSTALLATION (Cont.)
Fig. 8-1 Install diverter bracket (if applicable)
Burner
pan
Flame
diverter
bracket
2-
1
/4"
Pilot assembly
installed
Fig. 8-2 Install pilot assembly
Fasten pilot
assembly to
bracket
(Valve not shown
for clarity)
(Valve not shown)
INSTALL THE FLAME DIVERTER BRACKET
For installation on G4/G45 burners only. When properly
installed onto the burner pan, the flame diverter bracket
will promote quicker ignition and protect the safety control
system from overheating.
Note: You must first install the flame diverter bracket
before installing the pilot/igniter assembly .
1. Place the flame diverter bracket over the side edge
of the burner pan, near the location the safety control
system pilot bracket will be attached. It should be
placed approximately 2-
1
/
4
" from the rear wall of
the burner pan (see Fig. 8-1).
2. Tap the bracket lightly with a hammer to secure it in
place.
INSTALL THE PILOT/IGNITER ASSEMBLY TO
THE BURNER
CAUTION: Do not kink or damage the pilot supply tube,
sparking, and sensor probes. Do not unscrew
the gas line from the valve.
1. Using the two (2) remaining screws, mount the pilot
assembly onto the bracket (from below) and tighten
until snug (Fig. 8-2). Check to be certain the pilot
hood and probes are situated above the edge of
the pan. Adjust if necessary.
2. The valve is shipped with the pilot supply tube bent in
an ideal manner to prevent damage / unsafe operation,
and to allow for proper heat shield placement. Maintain
this orientation at all times (reference figures on
following page).
WARNING: Keep the pilot/igniter assembly clear at all
times. Never cover any part of the pilot/
igniter assembly.