Spec Sheet 1

11
L-A2-376
Rev 1 - 1904120815
HEAT SHIELD
MUST BE
PROPERLY
PLACED
INSTALLATION (Cont.)
Burner pan
Fig. 11-3 2V models: Place heat shield
Burner pan
Fig. 11-4 3V models: Place heat shield
Heat
shield
Heat
shield
Fig. 11-1 Connect cord to module / power supply
Fig. 11-2 Install/replace transmitter batteries
Remove
lid for
battery
access
CONNECT TO A POWER SUPPLY
Locate the supplied power supply and connect it to the
ignition module pack. Then route it to the previously wired
120VAC (15 AMP minimum) GFCI GROUNDED 3-wire
receptacle and connect (see Fig. 11-1).
INSTALL/REPLACE REMOTE TRANSMITTER
BATTERIES
CAUTION: Ensure the unit is connected to the gas line
and has been tested for leaks before you
insert batteries.
The remote transmitter requires 3 "AAA" batteries to
operate (included). Locate the transmitter, remove the
lid (found on rear), and properly insert new batteries as
marked. Re-secure the lid. See Fig. 11-2.
HEAT SHIELD PLACEMENT
TO PREVENT VALVE DAMAGE AND FAILURE:
IT IS CRITICAL THAT THE HEAT SHIELD BE
PLACED CORRECTLY OVER THE VALVE PRIOR
TO OPERATION.
TO PREVENT OVERHEATING THE VALVE:
Cover the valve with the heat shield as shown in Fig. 11-3
or Fig. 11-4. It should rest flat above the valve.
The switch wire connecting the heat shield to the
ignition module pack is to be routed along the interior
right side of the heat shield. Keep all wires inside of the
heat shield and/or away from the flame. Keep the area
above and below the heat shield clear of decorative
media or any other objects at all times.
Important: Ensure the pilot supply tube does not
interfere with heat shield placement. For
2V models, the tube will come out of the
rear and coil back to the pilot. For 3V
models, the tube will come out of the left
side of the heatshield and coil to the pilot.
Important: Keep lava granules/coals, sand/vermiculite,
embers/glass, and all foreign objects away
from the pilot assembly, valve assembly, and
heat shield during media placement and at
all times.
DECORATIVE MEDIA REPLACEMENT
Refer to the burner instructions for proper replacement
of decorative media.
Important: Keep lava granules/coals, sand/vermiculite,
embers/glass, and all foreign objects away
from the pilot assembly, valve assembly, and
heat shield during media placement and at
all times.
HEAT SHIELD
MUST BE
PROPERLY
PLACED
Receptacle
MUST be:
120VAC (15 AMP
minimum) GFCI
GROUNDED 3-wire