Manualshelf

Spec Sheet 1

ManualsBrandsReal Fyre ManualsFireplace/Gas Stove AccessoriesVent-Free Collection ECV-2-24 24" Evening Fyre Charred See Thru Logs with Variable Flame Height Remote, On/Off Remote with Standing Pilot and 25,000 to 38,000 BTUS in Brown
123456
6
EVENING FYRE & EVENING FYRE CHARRED LOG PLACEMENT INSTRUCTIONS (24" & 30" MODELS) (CONT.)
5
6
7
V
VI
Place the right middle log (log #5) as shown. The log should
lock in place over the logs below.
Place the left top log (log #6) as shown. The log should lock
in place over the logs below.
Place the center top log (log #7) as shown. The log should
lock in place over the logs below.
VII
After setting the logs into position as described above, ensure each is properly and fi rmly seated. The
vent-free gas log set will not function as intended if the logs are not correctly positioned. When placed
properly, the fl ames will not strike any portion of the logs. Periodically check the positioning of all logs to
ensure proper log placement and stability. If any fl ame is striking the logs, recheck log placement. Adjust
to conform with instructions. There should be no fl ame impingement on the logs.
15 model shown
Side view
Front view
(place both sides)
1" (minimum)
Place the decorative wood chips in front of the burner. Ensure
the charred ends face inward. For the wood chip in front of
the valve, ensure at least 1" between it and the valve.
CAUTION: Ensure the wood chip in front of the
valve is at least 1" away from the valve
to avoid overheating and damage to the
valve. If this minimum requirement of
1" clearance is not possible, DO NOT
use the wood chip.
CAUTION: THE WOOD CHIPS WILL BE HOT DURING
AND AFTER OPERATION.
8
Final Log Placement
IX
VIII