Spec Sheet 1

5
CHARRED FRONTIER OAK & CHARRED AGE SPLIT LOG PLACEMENT INSTRUCTIONS (24" & 30" MODELS)
III
III
IV
CH(FR,AS)-24 & CH(FR,AS)-30
PARTS LIST
CHFR-24 log set shown
1
2
4
3
5
6
24" - CH(FR,AS)L-20BR
30" - CH(FR,AS)L-24BR
24" - CH(FR,AS)L-24BF
30" - CH(FR,AS)L-30BF
CH(FR,AS)L-12TL
CH(FR,AS)L-10T
Place the rear log (log #1) as shown. Slide it forward on
the grate, against the main burner bracket. The cutouts
found on the underside of the log should align over the
grate fi ngers. ENSURE THE LOG RESTS FLAT ON THE
BURNER/GRATE.
2
Place the front log (log #2) as shown. Slide it back on the
grate, against the main burner bracket. The cutouts found on
the underside of the log should align over the grate fi ngers.
ENSURE THE LOG RESTS FLAT ON THE BURNER/
GRATE.
Ensure the rear and front logs are snug up against the main
burner bracket.
V
Place the left middle log (log #3) as shown. The log should
lock in place over the logs below.
Place the right middle log (log #4) as shown. The log should
lock in place over the logs below.
CH(FR,AS)L-12TR
7
CH(FR,AS)L-9T
CH(FR,AS)L-7T
1
Logs snug against bracket
The underside of the bottom logs have cutouts and tabs that align over the burner. THE BOTTOM LOGS
MUST BE FULLY SEATED ON THE BURNER. Certain logs have notches on them to allow for the logs to
interlock in place.
All items for this log set are included in one (1) box.
CAUTION: Burn hazard! Logs will remain hot
for some time after use.
Select G10 burner systems include a
decorative wood chip. If equipped, refer
to the INSTALLATION section of the main
owner’s manual supplied with the burner for
placement.
3
4