Spec Sheet 1

BEGIN WITH THE GENERIC LOG, BOOSTER GRID, AND EMBER STEPS BELOW, THEN LOCATE THE PAGE FOR

YOUR LOG SET SIZE CHOSEN TO COMPLETE PLACEMENT.

Generic Placement Steps

All models begin with the bottom log and ember placement shown below. To complete log placement continue

to the appropriate section (on one of the following pages) speciﬁ c to your log set size.

BURNT ASPEN LOG PLACEMENT INSTRUCTIONS

Ember stop

(part of frame)

Place the rear log (log #1) as shown. The log should be

slid back on the burner until it hits the backstop.

The ember stop at the front of the shelf serves to conﬁ ne

the embers B in place. Place and pack a level amount of

embers B on the shelf in front of the rear log as shown.

• PACK THE EMBERS DOWN

(to reduce heat transfer to components below).

• Save a small amount of embers for placement on the

radiant booster grid.

Place embers B as shown

Place the radiant booster grid as shown above and in the

next image. The grid should rest against the rear log. The

ember stop has notches to properly align the grid in place.

Ensure the embers are level and packed in place.