User manual

171
Setting the Pass Through Interface-
After completing the Controller Calibration… and the Channel Mapping…
procedures, select the desired aircraft. Next, select the Edit Current Aircraft menu
item. Highlight the aircraft root (name of the aircraft) and select the value for the
Radio Type. Using either the mouse or the up/down arrow keys on the keyboard,
select the Pass Through option from the pull-down menu.
Mapping channels to Servos-
If any channels are mapped to the wrong functions on the aircraft, edit the aircraft
using the following procedure. Click the Edit Current Aircraft menu item. Access
the Electronics options. Double-click the Electronics name or click on the [+]
(plus). Select the incorrectly mapped channel from the pull-down list that activates.
To change the respective channel of operation, click on the corresponding value and
select the appropriate option from the pull-down list.
IMPORTANT! Do not change the servo mapping using the Channel Mapping…
menu item. If you do so, the change will also affect ALL stock aircraft. Instead,
simply change the servo mapping using the Electronics options above for a single
aircraft.
Sharing Aircraft that use the Pass Through Interface-
In most cases, when you make a custom aircraft that uses the Pass Through Interface
option, you will not be able to provide that aircraft to your friends or submit it to the
RealFlight Model Swap Page. This is because the RealFlight software does not receive
the necessary input for the radio programming. Consequently, you would have to
provide other RealFlight users with all of your R/C radio’s settings for that particular
aircraft. Moreover, they would have to have the exact same R/C transmitter in order
for them to use the aircraft. These complications effectively prohibit swapping aircraft
under these conditions.
InterLink Elite Controller Tips
What if my transmitter has fewer channels than the model I
select?
This issue can arise when you use your own transmitter to control RealFlight 6.5. In
this situation, we highly recommend that you use the InterLink Elite controller.
When to use the Channel Mapping, and when to use the Software
Radio or Servo page-
This issue arises only if you use your own transmitter to control RealFlight. When you
use the InterLink Elite controller as a mockup transmitter, you should not alter the
Channel Mapping.