User manual

13
Follow the on-screen instructions to complete the setup procedure. Upon
completion of the installation, click OK.
Installing or Updating DirectX-
1. RealFlight will ask if you wish to install DirectX 9 on your PC. It is
important that your PC utilizes DirectX 9.0c or later. Click OK to
proceed to the DirectX License Agreement.
2. Click "I accept the license agreement" to install DirectX 9.0c.
Alternatively, if you do not wish to update DirectX at this time, click
Cancel.
3. If you have opted to accept the license agreement, click Next to
proceed with the installation. DirectX will install the necessary files to
update your PC.
4. When prompted, click Finish. Your PC will power down and then
restart once again.
Connect the InterLink Controller-
The InterLink controller uses the USB (Universal Serial Bus) port, so there is
little to do in the way of setup.
1. With the software installation procedure complete, firmly plug the
InterLink controller into an available USB port on the PC. Because
the controller is hot swappable, you do not have to shut the PC down
to plug the controller in.